Solving Usb Flash Drive Problems - HP ProDesk 600 Maintenance And Service Manual

Maintenance and service guide - hp prodesk 600 g1 tower, hp prodesk 600 g1 small form factor
Hide thumbs Also See for ProDesk 600:
Table of Contents

Advertisement

Recording or copying CDs is difficult or impossible.
Cause
Wrong or poor quality media type.

Solving USB flash drive problems

If you encounter USB flash drive problems, common causes and solutions are listed in the following
table.
USB flash drive is not seen as a drive letter in Windows.
Cause
The drive letter after the last physical drive is not available.
USB flash drive not found (identified).
Cause
The device is attached to a USB port that has been hidden in
Computer Setup.
The device was not properly seated before power-up.
System will not boot from USB flash drive.
Cause
Boot order is not correct.
Removable Media Boot is disabled in the Computer Setup
utility.
The computer boots to DOS after making a bootable flash drive.
Cause
Flash drive is bootable.
Flash drive is defective.
182
Chapter 8 Troubleshooting without diagnostics
Solution
1.
Try using a slower speed when recording.
2.
Verify that you are using the correct media for the drive.
3.
Try a different brand of media. Quality varies widely
between manufacturers.
Solution
Change the default drive letter for the flash drive in Windows.
Solution
Run the Computer Setup utility and enable USB ports in
Security > USB Security.
Ensure the device is fully inserted into the USB port before
applying power to the system
Solution
Run the Computer Setup utility and change boot sequence in
Storage > Boot Order.
Run the Computer Setup utility and enable booting to
removable media in Storage > Storage Options. Ensure
USB is enabled in Storage > Boot Order.
Solution
Install the flash drive only after the operating system boots.
Try a different flash drive.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prodesk 600 g1 towerProdesk 600 g1 small form factor

Table of Contents