HP ProDesk 600 Maintenance And Service Manual page 132
Maintenance and service guide - hp prodesk 600 g1 tower, hp prodesk 600 g1 small form factor
Hide thumbs
Also See for ProDesk 600:
- Hardware reference manual (112 pages) ,
- Quickspecs (58 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
6.
Remove the cables from the cable clip under the drive cage.
7.
Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
8.
Press the tab on the right side of the assembly (2) to disengage it from the chassis.
9.
Push the assembly into the chassis (3), and remove it from the chassis.
To install the front I/O assembly, reverse the removal procedure.
NOTE:
Be sure to correctly route the cables beneath the drive cage when reinstalling the assembly.
Proper cable routing prevents damage to the cables and allows the drive cage to close properly. See
Cable routing on page 120
122
Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
for proper cable placement.
- Quick Links:
- Tower (Twr)
- Small Form Factor (Sff)
Hide quick links:
Advertisement
Table of Contents
