HP ProDesk 600 Maintenance And Service Manual page 134
Maintenance and service guide - hp prodesk 600 g1 tower, hp prodesk 600 g1 small form factor
Hide thumbs
Also See for ProDesk 600:
- Hardware reference manual (112 pages) ,
- Quickspecs (58 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
6.
Remove the cable from the cable clip under the drive cage.
7.
From the inside of the chassis, press down on the tab on the top of the power switch (1) to
disengage the power switch from the chassis.
8.
Pull the power switch out the front of the chassis (2), while routing the cable through the hole in
the chassis.
To install the power switch assembly, reverse the removal procedure.
NOTE:
Be sure to correctly route the cables beneath the drive cage when reinstalling the assembly.
Proper cable routing prevents damage to the cables and allows the drive cage to close properly. See
Cable routing on page 120
124
Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
for proper cable placement.
- Quick Links:
- Tower (Twr)
- Small Form Factor (Sff)
Hide quick links:
Advertisement
Table of Contents
