TP-Link TL-ER604W User Manual page 69

The following items are displayed on this screen:
 General
Disable Bandwidth
Control:
Enable Bandwidth
Control all the time:
Enable Bandwidth
Control When:
 Default Limit
Limited
Bandwidth:
 Interface Bandwidth
Interface:
Upstream
Bandwidth:
Downstream
Bandwidth:
Note:
● The Upstream/Downstream Bandwidth of WAN port you set must not be more than the bandwidth
provided by ISP. Otherwise the Traffic Control will be invalid.
● If there are data flowing into the Router from interface A and out from interface B while the
downstream bandwidth of A is different from the upstream bandwidth of B, then the smaller one
should be considered as the effective bandwidth, and vice versa.
● Click the <View IP Traffic Statistics> button to jump to IP Traffic Statistics page.
Select this option to disable Bandwidth Control.
Select this option to enable Bandwidth Control all the time.
With this option selected, the Bandwidth Control will take effect when the
bandwidth usage reaches the specified value.
Default Limit applies only for users that are not constrained by Bandwidth
Control Rules. These users share certain bandwidth with upper limit
configured here. Value 0 means all the remained bandwidth is available to
use.
Displays the current enabled WAN port(s). The Total bandwidth is equal to
the sum of bandwidth of the enabled WAN ports.
Displays the bandwidth of each WAN port for transmitting data. The
Upstream Bandwidth of WAN port can be configured on WAN page.
Displays the bandwidth of each WAN port for receiving data. The
Downstream Bandwidth of WAN port can be configured on WAN page.
-64-