Overcasting; Satin Stitch - Bernina 830LE Manual

Overcasting

with Zig-Zag Stitch no. 2
► guide edge of fabric into the center of the presser foot
► do not select too wide a width or too long a stitch – the
edge should lie flat and not roll
► needle goes into fabric on one side and over the edge
into the air on the other side
► use a fine darning thread for lightweight fabric

Satin Stitch

► dense stitch used for appliqué, embroidery, etc.
► shorten stitch length, satin stitch setting will be indicated
by parallel lines on stitch length bar
► Reverse pattern foot no. 1C
If edges roll:
► use the Vari-overlock stitch and foot
no. 2A
T The sewing computer has a programmed satin
s stitch: no. 1354
91