Network Setup (Lan Cable Connection) - Kyocera FS-1028MFP Operation Manual

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings,
refer to Network Setup on page 8-127.
• TCP/IP (IPv4) Setup ...2-11
• AppleTalk Setup ...2-20
TCP/IP (IPv4) Setup (by Entering IP Addresses)
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway
addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off".
NOTE:
Prior to the IP address entries, obtain permission from the network administrator.
Use the procedure below to setup the TCP/IP (IPv4) setting.
Login User Name:
********************
Login Password:
Sys. Menu/Count.: a b
1 Report
2
Counter
3 System
*********************
Administrator only.
OPERATION GUIDE
1
L b
NOTE:
[ Login ]
5 for details on entering characters.
2
[ Exit ]
IMPORTANT: To make the settings, you must have
logged in using a user ID with administrator privileges.
The default settings of the login user name and login
password are both 2800.
If you have logged in using a user ID without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in.
Refer to Character Entry Method on Appendix-
In the Sys. Menu/Count. menu, press the
key to select [System], and then press the OK key.
Preparation before Use
or
2-11
2