Kyocera FS-1028MFP Operation Manual page 56

Preparation before Use
DHCP Settings
Select whether or not to use the DHCP server. The default setting is On.
Use the procedure below to specify the DHCP setting.
Login User Name:
********************
Login Password:
Sys. Menu/Count.: a b
1
Report
2
Counter
3 System
*********************
Administrator only.
System:
1 Network Setting
*********************
2 I/F Block Set.
3
Security Level
Network Setting: a b
1 TCP/IP Settings
*********************
2 NetWare
3
AppleTalk
2-16
1
L b
NOTE:
[ Login ]
5 for details on entering characters.
2
[ Exit ]
IMPORTANT: To make the settings, you must have
logged in using a user ID with administrator privileges.
If you have logged in using a user ID without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
3
a b
[ Exit ]
4
[ Exit ]
5
Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in.
Refer to Character Entry Method on Appendix-
In the Sys. Menu/Count. menu, press the
key to select [System], and then press the OK key.
In the System menu, press the
[Network Setting].
Press the OK key. The Network Setting menu
appears.
Press the or key to select [TCP/IP Settings].
or
or key to select
OPERATION GUIDE