Xerox DocuPrint 240A User Manual page 16

4. Select [Other], and click [FX TCP/IP DPU Port] from [Click the type of port you want to
add].
5. Click [OK].
The [FX TCP/IP Direct Print Utility Port Setup] dialog box is displayed.
6. Enter the appropriate value for each item, and click [OK].
Example: For port name, "Trans5" and IP address, "129.249.242.179".
Port Name
IP Address
Protocol
Note
• If you do not know the IP address of the printer, check with your network administrator, or print out the
[System Settings List]. Refer to the Setup and Quick Reference Guide.
Refer to
• For each setting item: Online Help for the TCP/IP Direct Print Utility
16
2 Printing Using TCP/IP Direct Print Utility
Enter a name of your choice to identify the printer.
Important
• When you are adding multiple TCP/IP Direct Print Utility ports, do
not use port names as in the following.
There is no difference between using uppercase or lowercase
characters. Example of port names that cannot be used (current
port name is "printer"):
• Adding characters at the end of the current port name.
Example: "printer1", "printer-01" and so forth.
• Deleting some characters from the current port name.
Example: "prin", "print" and so forth.
Enter the IP address of the printer. If the Domain Name System (DNS)
has been installed, the printer host name can be entered.
Select the protocol to be used for data transfer.
LPR: The LPD protocol is used for printing.
Raw: Port9100 protocol is used for printing. You can specify a port
number at the destination in [Port Number].