Standard Horizon SPECTRUM GX2350S Owner's Manual page 9

WX Key
Immediately recalls the previously selected NOAA weather channel
from any channel location.
Secondary use
1. Holding down the 16/9 key while pressing the WX key changes the
mode from USA to International or Canadian.
If position is displayed, this icon will be hidden.
2. Holding down the WX and SCAN key while turning the power on resets
the microprocessor and erases scan channels from memory. This clears
the memory and establishes the factory-set defaults. For a list of these
defaults, see the section on Resetting the Transceiver's Microprocessor.
SCAN Key
1. Starts and stops scanning of programmed channels.
2. If held while the UP or DOWN key on the mic case is pressed or channel
knob on radio is turned, the radio will show the channels in scan memory.
This function will not work if the unit is scanning.
There is only one priority channel. However, it can be assigned to a
channel other than WX and CH70. The priority channel is marked with
P-CH on the LCD.
MEM Key
Memorizes the selected channel into the transceivers scan memory for
scanning. When pressed again it, DELETES the channel from the scan
memory.
Secondary use
The MEM key is also used to select a priority channel.
1. Select the desired channel.
2. Press and hold the MEM key until the display shows P-CH.
If position is displayed, this icon will be hidden.
DISTRESS Key
To send the distress call see section 6.2, (Sending a Distress Call).
PA/FOG key
Available to operate the PA function or the FOGHORN function
GX2350S
NOTE
NOTE
NOTE
Owner's Manual page 6