Figure 2-1. Sample Bootptab File - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers
# "bs" indicates the size of the boot file. If you specify
# "auto" as the size, the BOOTP server calculates the size of
# the file for each BOOTP request.
:bs=auto:\
# "vm" indicates that the BOOTP server should always reply in
# a manner compliant with RFC 1048. You must enter rfc1048
# for this tag so that the AN can understand the BOOTP
# responses it receives.
:vm=rfc1048:
# This line marks the beginning of the active definition for
# the AN we are naming "AN.Boston."
AN.Boston:\
# "ip" indicates the IP address of the AN.
:ip=192.32.5.2:\
# "T130" indicates the size of the AN's configuration file in
# 512-byte blocks. Always use 0x0004.
:T130=0x0004:\
# "T129" indicates the pathname of the configuration file
# for the AN.
:T129="/usr1/cfg/AN_Bost.cfg":\
# "tc" indicates that the "general" definition contains more
# information that applies to BOOTP transmissions to
# "AN.Boston."
:tc=general:
# This is the active definition for the AN we are naming
# "AN.Chicago."
AN.Chicago:\
:ip=10.0.0.4:\
:T130=0x0004:\
:T129="/rte3/cfg/AN_Chic.cfg":\
:tc=general:
Figure 2-1.
2-8
Sample bootptab File (continued)
308614-14.20 Rev 00