Adding A Netboot Or Directed Netboot Interface - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers

Adding a Netboot or Directed Netboot Interface

When you enable Netboot or Directed Netboot, you must add (and configure) at
least one AN/ANH or ARN router circuit as a Netboot interface. If you are using
EZ-Install, you do not need to configure Netboot interfaces. You can use Site
Manager to add a Netboot interface.
You do this
1. In the Configuration Manager window,
choose Protocols.
2. Choose Global Protocols.
3. Choose Net Boot.
4. Choose Interfaces.
5. Click on Add.
6. Set the Connector parameter.
Click on Help or refer to the parameter
description on page A-4.
7. Click on OK.
3-8
Site Manager Procedure
System responds
The Protocols menu opens.
The Global Protocols menu opens.
The Net Boot menu opens.
The Netboot Interfaces window opens.
The Netboot Interface window opens.
You return to the Netboot Interfaces
window, which shows the interface you
just added.
308614-14.20 Rev 00