Setting Up Routing Paths For Netboot; Enabling Router Interfaces - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring Remote Access for AN and Passport ARN Routers

Setting Up Routing Paths for Netboot

You set up the routing paths between the BootP server and the AN/ANH or ARN
router by:
• Enabling each router interface in the paths to the routers
• Creating a BootP relay agent forwarding table for each router in a path
• Creating a BootP client interface table for the upstream router when the router
is on a Frame Relay PVC in group access mode

Enabling Router Interfaces

You must enable BootP relay (also called BootP pass-through or gateway) on all
interfaces in the paths between AN/ANH or ARN routers and the BootP server.
For example, you would enable BootP relay on the interfaces indicated in
Figure
3-10
3-1.
308614-14.20 Rev 00