Simrad AP50 Instruction Manual page 129

Abbreviated
name
GPS1
GPS2
ECS1 *
ECS2 *
GYRO1
GYRO2
THD1
THD2
MAGN1
MAGN2
FLUX1
FLUX2
WIND
DEPTH
LOG
Output INSTR
Output RADAR
* Automatic course change at waypoint will now occur during navigation in NAV
mode.
** For future use.
Output signal
Continuous output of 10 Hz
NMEA compass heading
20221032B
Equipment / Usage
Primary GPS/Chart Plotter
Backup GPS/Chart Plotter
Primary Electronic Chart
System
Backup Electronic Chart
System
Any primary gyro
Backup gyro for GYRO1
Transmitting Heading Device
Transmitting Heading Device
Magnetic compass with
course detector (CD100A)
Magnetic compass with
course detector (CD100A)
For use with fluxgate
compasses
For use with fluxgate
compasses
For wind sensor
For depth sensor
For speed sensor
NMEA output of compass
heading
or VDR data
Clock/data heading output to
radars
Output terminal
Junction unit, Power PCB,
NMEA2, TX2+, TX2–
Table 5-2 Permanent NMEA Output on Port 2
Software Set-up Procedure
NOTES
Can be used as either Nav. source
or Speed source
NMEA, syncho or step signal input
NMEA input
1) CD100A + CDI35 connected to
J50
2) CD100A directly connected to
CI300X
RobNet, NMEA, sine/cosine or J50
Heading Sensor (HS) input
NMEA input
NMEA or pulse log
HDG or HDT output increased
from 1 to 5 times/sec. on TX1 port.
HDT and RSA 5x/sec.
May select Simrad, Furuno, or
Special** (for both J50 and
NI300X)
Table 5-1 Interface Menu
Output sentence
HDT or HDG
(input dependent)
127