Simrad AP50 Autopilot
4.13 FU50 Steering Lever
4.14 TI50 Thruster Interface
4.15 AD50 Analog Drive
102
RFC35 Fluxgate Compass
The RFC35 Fluxgate Compass can be connected to the J50
Junction Unit, but the compass is not recommended for
commercial use.
RFC35
FLUXGATE
COMPASS
Figure 4-28 RFC35 connection
• Change in the Installation Interface menu: Select FLUX =
J50-HS.
For connection of the FU50 Steering Lever, see the FU50
manual.
The TI50 Thruster Interface is designed to provide control signal
for operating one thruster in an AP50 system by either on/off
solenoid, continuous control, or Danfoss PVEM valve.
Refer to separate manual for the TI50 Thruster Interface.
The AD50 Analog Drive is designed to provide analog or
proportional control of a rudder in an AP50 system by either
continuous voltage, or Danfoss PVEM valve signal.
Refer to separate manual for the AD50 Analog Drive.
JUNCTION UNIT
MAIN PCB
Heading
Sensor
*
* NON POLARIZED
(COLOR INDEPENDENT)
20221032B