Getting Started
Powering ON the projector
1.
Connect the power cord to the P3.
2.
Connect the wall plug into the wall power source.
3.
Press POWER button and hold for 2-3 seconds to switch on or switch off
the power.
4.
The projector will boot with a boot screen and finish booting to the media
player's Main Menu.
5.
If the projector does not boot to the "Main Menu" Press "SRC", select "Me-
dia" to start the Media Player
•
4 hours of charge time is required to reach a full charge.
•
When charging, the inside of the P3 will glow red.
•
When fully charged, the inside of the P3 will turn blue.
Powering OFF the projector
1.
Press and hold the power button for 3 seconds.
2.
The optical engine should power off and the fan should stop spinning.
Note: The P3 Projector battery does not charge when it is in operation.
Chapter 2
5