Table of Contents
Advertisement
Technical Details
Troubleshooting
IMAGE IS BLURRED
Possible Causes
The Projector is not in focus
The Projector is offset from plane / angle of
operation
No Sync, No Signal
1.
Be sure to setup the computer to enable a video signal output. On some
laptops this is done by pressing and holding Function F5 key. If using
the P3 as an external monitor on Windows based systems, this can be
done by selecting "extend my desktop to this monitor".
the video driver different resolutions may need to be selected for proper
output.
Chapter 4
Solution
Adjust the focus with the focus adjustment dial
until the image comes into focus
Move the projector so that it is both 180 degrees
and on an evern plane with the screen.
Depending on
22
Advertisement
Table of Contents
