Switching The Device On/Off; Switching On/Off Using The Vehicle Ignition - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

INTRODUCTION NAVIGATION

Switching the device on/off

1 To switch on your TravelPilot E1/E2, press button 3.
The device plays the last active audio source at the volume level that was
set when the device was last switched off. You can limit the power-on vol-
ume to a maximum value.
Note: You can find out how to limit the power-on volume in the sec-
tion entitled "Configuring the power-on / navigation / traffic an-
nouncement / telephone volume and GALA settings" in the "Setup -
basic settings" chapter.
1 To switch off the device, press and hold down button 3 for longer than
2 seconds.

Switching on/off using the vehicle ignition

The TravelPilot E1/E2 will switch on/off simultaneously with the vehicle ignition
if it is correctly connected to the vehicle ignition and if you did not switch off the
TravelPilot by pressing button 3.
You can also operate the TravelPilot E1/E2 when the ignition is off.
1 To do so, press button 3.
The device switches off automatically after an hour so as to protect the vehicle
battery. You can repeat this procedure as often as you like. The imposed time
limit is cancelled as soon as the ignition is turned on.
Note: To ensure that the TravelPilot E1/E2 functions properly, the
device must be connected to the permanent positive power source
and to the positive power source via the ignition as described in the
installation instructions. The standby time that elapses after the
device is switched off has been set to 30 minutes.
RADIO CD / MP3 CD CHANGER SETUP
3
APPENDIX
14