Scanning All The Tracks On A Cd (Scan); Repeating Tracks (Repeat); Traffic Announcements During Cd Mode - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

INTRODUCTION NAVIGATION
To cancel the MIX function,
1 press the 2 MIX station button > again. The MIX function is automatically
cancelled if you activate the SCAN function.

Scanning all the tracks on a CD (SCAN)

If you briefly want to play (scan) all the tracks on a CD, proceed as follows:
1 Press and hold down the OK button ; for longer than 2 seconds.
All the tracks on the CD are scanned in ascending order. The scanning time
is 10 seconds.
To cancel the SCAN function,
1 press the ESC button =. The SCAN function is automatically cancelled if
you activate the MIX function.

Repeating tracks (REPEAT)

To repeat a track, activate the repeat function.
1 Select the track that you want,
2 press the 5 RPT station button >.
The track is repeated until you cancel the repeat function.
If you want to cancel the repeat function,
1 press the 5 RPT station button > again.

Traffic announcements during CD mode

To switch traffic announcement standby on/off (see the section entitled " T raffic
information" in the " R adio mode" chapter) whilst in CD mode,
1 press the TRAF button @.
The symbol is shown in the display when traffic announcement standby
is activated.
RADIO CD / MP3 CD CHANGER SETUP
scan CD
TRACK 6
TMC O:O8
RP= =rack
TRACK 2
TMC
2:33
CD
TRACK 7
TMC 3:24
APPENDIX
60