Entering A Destination - From The Destination Memory - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

Entering a destination – From the destination memory
You can store destinations in the destination memory that you drive to regularly
so you can access them easily for other navigation sessions. For further infor-
mation, read the section entitled " D estination memory" .
The navigation system has four memory banks at its disposal (N1, N2, N3 and
N4). Six destinations can be stored in each memory bank.
To access destinations from the destination memory,
1 press the NAV button 1.
The main navigation menu and the memory bank that was active last are
displayed.
2 Press the NAV button 1 repeatedly until the memory bank that you want is
displayed.
3 Press one of the 1 - 6 buttons > that corresponds to the stored destination.
The destination that is assigned to the button you selected is displayed.
4 If you want to use the destination for navigation, press the OK button ;.
Navigation begins. For further information, read the section entitled " N aviga-
tion" .
Note: If necessary, you will be asked to insert the navigation CD-
ROM if it is not already present in the CD drive.
INTRODUCTION NAVIGATION RADIO CD / MP3
N1 DES=N 2
BERLIN [D]
, BERLIN,
TMC
UNTER DEN
LINDEN
CD CHANGER SETUP
NAV
37
APPENDIX