AUDIO button to adjust the panel. bass, treble, balance and fader settings. FMT button (Essen CD31) to se- lect the FM memory levels, Arrow buttons. to switch to radio mode, MENU button to open the basic to start the Travelstore function.
Only operate your car radio if the CDC A 071 CD changers by using an road and traffic conditions allow you adapter cable (Blaupunkt no. 7 607 889 to do so. Familiarise yourself with the 093). unit before setting off on your jour- ney.
Store the control panel in the sup- plied case (Alicante CD31 only). Avoid making direct skin contact with the control panel’s contacts. If necessary, clean the contacts with a lint-free cloth soaked in cleaning spirits.
SWITCHING ON/OFF Switching on/off Switching on by inserting a CD If the unit is switched off and there is no There are various ways of switching the CD inserted in the drive, unit on/off: Gently insert the CD with the print- Switching on/off using the vehicle ed side uppermost into the drive ignition...
ADJUSTING THE VOLUME Adjusting the volume Instantaneous volume reduction (mute) The system volume can be adjusted in steps from 0 (off) to 66 (maximum). This feature allows you to instantane- ously reduce (mute) the volume to a lev- To increase the system volume, el preset by you.
ADJUSTING THE VOLUME Confirmation beep For some functions you will hear a con- firmation beep if you keep a button pressed for longer than two seconds. For instance, after storing a radio sta- tion to a station button you will hear a confirmation beep.
RADIO MODE use the REG function to prevent Radio mode the car radio from switching to al- This unit is equipped with an RDS radio ternative frequencies that are receiver. Many of the receivable FM sta- transmitting different programme tions transmit a signal that not only car- content.
The MW and LW frequency ranges are not available on the Essen Keep pressing the button CD31. 9 until “SENS” appears in the dis- There are three preset memory levels play. for the FM range and one for each of button 9.
FMT memory or MW / LW frequen- Starting SCAN cy range (MW and LW are not Press the SCAN button 4. available on the Essen CD31). Tune into the station. Scanning begins. “SCAN” appears brief- ly in the display followed by the current Press one of the station buttons 1 - frequency (which flashes).
RADIO MODE Note: Setting the scantime If no station is found that corre- Press the MENU button :. sponds to the selected programme Keep pressing the button type, you will hear a beep and “NO 9 until “SCANTIME” appears in PTY”...
RADIO MODE The selected programme type is dis- Treble reduction feature during played briefly. interference (HICUT) button 9 to start Press the The HICUT function improves the sound seek tuning. when radio reception is poor (FM only). When interference is being experi- The next station corresponding to your enced, the treble is automatically cut, selected programme type will then be...
TRAFFIC INFORMATION RECEPTION Traffic information Setting the traffic announcement volume reception Press the MENU button :. Switching traffic information Keep pressing the button priority on/off 9 until “TA VOLUME” appears in Press the TRAF button <. the display. Traffic announcement priority is active Set the announcement volume us- when a traffic jam symbol lights up in buttons 9.
CD MODE button 9 once, If you press the CD mode the current track will be played again You can use this unit to play standard from the beginning. CDs with a diameter of 12 cm. Quick track selection Risk of damage to the CD drive! To quickly select tracks backwards or CD singles with a diameter of 8 cm forwards,...
CD MODE button 9. Stopping SCAN and continuing Press the playback The current setting is displayed. “TIME” To stop scanning, for the playing time display and “PLAY” for the track number display. press the SCAN button 4 again. button 9 to select the Press the The current track will then continue to required setting.
CD CHANGER MODE CD changer mode Fast searching (audible) To fast search backwards or forwards, Note: buttons 9 Information on handling CDs, in- keep one of the serting CDs and operating the CD pressed until fast reversing / fast changer can be found in the oper- forwarding begins.
CD CHANGER MODE Cancelling the repeat function Scanning all tracks on all CDs (SCAN) To stop the current track or current CD from being repeated, To scan all the tracks on all inserted CDs keep pressing button 3 (RPT) ; in ascending order, press the SCAN button 4.
CLOCK - TIME button 9 to CLOCK - Time Press the switch between the modes. Displaying the time When you have finished making your To display the time, changes, Keep the MENU ( ) button : press the MENU button :. pressed until the time appears in Displaying the time when the the display.
SOUND VOLUME DISTRIBUTION Sound Volume distribution Adjusting the bass settings Adjusting the balance settings To adjust the BASS, To adjust the left/right volume distribu- tion (balance), press the AUDIO button 8. press the AUDIO button 8. “BASS” appears in the display. “BASS”...
MP3 player. ranging from 1 to 3. If you want to connect an external au- “X-BASS OFF” means that the X-BASS dio source you will need a Blaupunkt feature is switched off. adapter cable (Blaupunkt no.: 7 607 897 093).
If you wish to enforce a claim under the FM frequency response: manufacturer’s guarantee that is provid- 35 - 16,000 Hz ed by Blaupunkt, please send the faulty unit together with the purchase receipt to the Blaupunkt customer service cen- Frequency response: tre in your country.
Need help?
Do you have a question about the Alicante CD31 and is the answer not in the manual?
Questions and answers