Page 1
Radio / CD / MP3 Kingston MP35 7 645 460 310 London MP35 7 645 450 310 Operating instructions http://www.blaupunkt.com...
Page 3
CONTROLS Button to switch the device on/ DIS button off and operate the volume mute Short press: Briefly display the function. clock time. Long press: Configure the dis- button, to open the flip-re- play. lease control panel SRC button Volume control Switch sources between radio, BND•TS button CD/MP3, CD changer (if con-...
You cannot switch the device on/off us- ing the remote control. Amplifiers You can use all Blaupunkt and Velocity amplifiers. CD changers You can connect the following Blaupunkt CD changers: CDC A 08, IDC A 09 and...
DETACHABLE CONTROL PANEL Detachable control panel (flip-release panel) Theft protection The device is equipped with a detacha- ble control panel (flip-release panel) as a way of protecting your equipment Note: against theft. The device is worthless The device will switch off after a to a thief without this control panel.
DETACHABLE CONTROL PANEL Note: Note: When attaching the control panel, If you set the off-timer to 0 sec- make sure you do not press the onds, the device will switch off im- display. mediately as soon as you open the control panel.
SWITCHING ON/OFF Note: Switching on/off To protect the vehicle battery, the There are various ways of switching the device will switch off automatically device on/off: after one hour if the ignition is off. Switching the device on/off using Switching on by inserting a CD the vehicle ignition If the device is switched off and there is If the device is correctly connected to...
ADJUSTING THE VOLUME When you have finished adjusting the Adjusting the volume setting, You can adjust the volume in steps from press the MENU button 7 twice. 0 (off) to 66 (maximum). To increase the volume, Quick volume reduction (mute) turn the volume control 3 clock- You can quickly decrease the volume wise.
You will need a cable for this with the following Blaupunkt number: 7 607 001 503. If the sound system receives a traffic announcement during a telephone call,...
RADIO MODE Radio mode Switching to radio mode If you are in CD/MP3, CD-changer or This device is equipped with an RDS AUX mode, radio receiver. Many of the receivable press the BND•TS button 4 FM stations broadcast a signal that not only carries the programme but also additional information such as the sta- press the SRC button ;...
RADIO MODE Switching REGIONAL on/off Tuning into stations manually Press the MENU button 7. You can also tune into stations manual- button 6 repeat- Press the edly until “REG” appears in the dis- Note: play. “OFF” or “ON” is displayed You can only tune into stations manually if the RDS function is de- alongside “REG”.
RADIO MODE button 6 repeat- Press the Press and hold down the BND•TS button 4 for longer than two sec- edly until “SENS” and the currently set value appear in the display. onds. “SENS HI6” means that the tuner is set The storing procedure begins.
RADIO MODE Note: Setting the scanning time If the tuner does not find a station Press the MENU button 7. that matches the selected pro- button 6 repeat- Press the gramme type, you will hear a beep edly until “SCAN TIME” appears in and “NO PTY”...
RADIO MODE “HICUT 0” means that the interference Set your preferred language using buttons 6. level will not be cut automatically. “HI- CUT 1” means that it will be cut auto- When you have finished adjusting the matically. setting, Press the MENU button 7. press the MENU button 7 twice.
TRAFFIC INFORMATION if you retune the radio from a traffic Traffic information information station to a station that Your device is equipped with an RDS- does not broadcast traffic informa- EON receiver. EON stands for En- tion. hanced Other Network. If you hear the warning beep, you can Whenever a traffic announcement (TA) either switch off traffic information pri-...
Problems might be ex- Playback begins from the point at which perienced when playing copy-protect- it was last interrupted. ed CDs. Blaupunkt cannot guarantee Selecting tracks the proper functioning of copy-protect- Press one of the arrow buttons 6 ed CDs! to select the next or previous track.
CD MODE Random track play (MIX) Repeating tracks (REPEAT) Press the 5 MIX button 9. If you want to repeat a track, press the 4 RPT button 9. “MIX CD” appears briefly in the display and the MIX symbol lights up. The next “RPT TRCK”...
CD MODE Displaying CD text Ejecting a CD button 2. Some CDs include CD text. The CD text Press the might contain the names of the artist, The control panel opens. album and track. button < next to the Press the You can allow the CD text to be dis- CD compartment.
MP3 MODE MP3 mode You can also use this car sound sys- tem to play CD-Rs and CD-RWs that contain MP3 music files. Preparing an MP3-CD The various combinations of CD burn- ers, CD burning software and CD blanks T001 T001 may lead to problems arising with the T002...
MP3 MODE “002”, etc.) at the beginning of each file Configuring the display name - you must include the leading An MP3-CD must already be inserted zeros. in the device before you can change the MP3 tracks can contain additional in- following settings.
MP3 MODE Configuring the MP3 scrolling text Selecting a directory One of the following scrolling texts is To move up or down to another directo- displayed once every time the track is changed. Afterwards, the configured button 6 once or press the default display is shown.
MP3 MODE To play the whole directory repeatedly, Cancelling MIX To cancel MIX, press and hold down the 4 RPT button 9 for longer than two sec- briefly press the 5 MIX button 9. onds. “MIX OFF” appears in the display and “RPT DIR”...
CD-CHANGER MODE CD-changer mode Configuring the display There are five display options available Note: for CD-changer mode: Information on handling CDs, in- Track number and playing time serting CDs and operating the CD (“TRCK-TIME”) changer can be found in the oper- ating instructions supplied with Track number and clock time your CD changer.
CD-CHANGER MODE Cancelling REPEAT Cancelling SCAN To stop the current track or current CD To stop scanning, from being repeated, briefly press the MENU button 7. briefly press the 4 RPT button 9. The currently scanned track will then continue to be played normally. “RPT OFF”...
REMOTE CONTROL CLOCK TIME Remote control CLOCK time Your car radio is equipped with an inte- Displaying the clock time grated infrared remote-control receiver. To display the clock time briefly, The receiver is built into the detachable DIS button :. control panel.
CLOCK TIME SOUND When you have finished adjusting the Sound setting, You can adjust the sound settings (bass press the MENU button 7. and treble) separately for each source (radio, CD/MP3 and CD changer / AUX). Displaying the time continuously You can boost or cut the bass and tre- when the device is off and the ble in steps of ±...
SOUND When you have finished adjusting the Setting the left/right volume setting, distribution (balance) press the AUDIO button 5. To adjust the left/right volume distribu- tion (balance), Adjusting the treble press the AUDIO button 5. Adjusting the treble boost/cut “BASS” appears in the display. Press the AUDIO button 5.
SOUND X-BASS Equalizer presets X-BASS This device is equipped with an equal- You can use the X-Bass feature to boost izer that has been preset with settings the bass at low volume levels. for the “ROCK”, “POP” and “CLASSIC” The selected X-Bass setting affects all music styles.
AMPLIFIER/SUB-OUT DISPLAY ILLUMINATION Amplifier/sub-out Setting the colour of the (only Kingston MP35) display illumination The car sound system provides connec- You can adjust the colour of the display tions that allow you to connect external illumination to suit the illumination of amplifiers.
DISPLAY ILLUMINATION BRIGHTNESS (DIMMER) Selecting a display illumination Adjusting the brightness colour during a scan (dimmer) You can select the colour of the display The display brightness will change when illumination during a “scan”. During the the headlights are turned on/off if your scan, the display shows all the possible car radio is connected as described in colour variations that are available in the...
6 repeatedly display. The factory default setting is the Press the “BLAUPUNKT” text. Instead of this, you until “AUTO DIM” appears in the can enter your own text up to 9 charac- display.
You can switch cable. You can obtain this cable (Blau- the level display on/off. punkt no.: 7 607 897 093) from your Press the MENU button 7. authorised Blaupunkt dealer. “MENU” appears in the display. Note: button 6 repeat- Press the If no CD changer is connected, the edly until “PEAK LVL”...
SPECIFICATIONS Specifications Amplifier Output power: 4 x 25 watts sine in accordance with DIN 45 324 at 14.4 V 4 x 45 watts max. power Tuner Wavebands in Europe: FM : 87.5 - 108 MHz MW : 531 - 1 602 kHz LW : 153 - 279 kHz FM frequency response:...
Page 36
Bitte den ausgefüllten Gerätepass sicher aufbewahren! Please keep the filled-in radio pass in a safe place! Prière de conserver soigneusement la carte d’autoradio remplie ! Tenete per favore il libretto di apparecchio, debitamente riempito, in un posto sicuro! Bewaar de ingevulde apparaatpas op een veilige plaats! Vänligen förvara ifyllt apparatpass på...
Page 38
Absatz „Programm-Typ (PTY)”. (GB) Note regarding PTY-EON reception If your Blaupunkt system switches from your chosen radio programme to another radio programme or from your chosen audio source (CD or CD changer) to a radio programme, please check whether you have activated the PTY (programme type) function.
Page 39
"Radio". (ES) Observaciones sobre la recepción PTY-EON Si su equipo Blaupunkt cambia de la emisora de radio que está escuchando a otra, o de la fuente de sonido seleccionada (CD o cambiadiscos) a una emisora de radio, verifique si tiene activada la función PTY (tipo de programa).
Page 40
(DK) Oplysning om PTY-EON-modtagelse Hvis din Blaupunkt radio slår fra det aktuelle radioprogram over i et andet eller fra en valgt kilde (CD eller Multi CD) over i et radioprogram, bør du tjekke om du har tændt for PTY (programtype).