Dynamic Navigation; Setup Appendix - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

Dynamic navigation

During dynamic navigation, the TravelPilot E1/E2 analyses digital traffic infor-
mation messages and uses this information when planning the route. The sys-
tem receives the traffic messages from TMC (Traffic Message Channel) sta-
tions. These are RDS stations that additionally broadcast their traffic messages
in digital form. If the system is already receiving a TMC station, the TMC symbol
will appear on the display.
If you want to make a currently active navigation session dynamic,
1 press and hold down the NAV button 1 for longer than 2 seconds during
the active navigation session.
A selection menu appears in the display.
2 Mark and confirm the ROUTE OPTIions menu item.
The menu for setting the route options appears.
3 Mark and confirm the DYNAMIC route option.
If the route option is activated, a filled-in square appears next to it.
Note: If you select dynamic navigation you can additionally choose
between a quick, short or optimum route calculation.
4 Press and hold down the OK button ; for longer than 2 seconds and then
press the ESC button =, or press the ESC button = twice.
The system calculates the route again and the navigation display appears.
Furthermore, the TMC symbol is displayed surrounded by a border.
Notes: If necessary, you will be asked to insert the navigation CD-
ROM if it is not already present in the CD drive. The system must be
tuned into a TMC station during navigation in order to provide dy-
namic navigation. The TMC symbol flashes if the system is not tuned
into a TMC station.
INTRODUCTION NAVIGATION RADIO CD / MP3
NAVI
TRAFF. JAM
ROUTE OPTI
TMC
ROU=E OP=ION
DYNAMIC
FAST
TMC
SHORT
OPTIMUM
FM1 NDR 2
10 16
pm
TMC
B6, WESTSC
HNELLWEG
CD CHANGER SETUP
NAV
o
o
NAV
16mi
NAV
43
APPENDIX