Navigation - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

INTRODUCTION

NAVIGATION

Navigation
Starting navigation
Once you have entered a destination, the destination address appears in the
display. If you want to start a navigation session in order to be guided to this
destination,
1 press the OK button ;.
Route calculation
After you activate navigation, the system will show a warning on the display for
approx. 5 seconds. Afterwards, the system starts calculating the route.
Plus Point: The system loads the route fully into the navigation memory when
it calculates and completes the route. This means you can remove the nav-
igation CD-ROM from the drive after the loading process is complete and
play an audio CD.
If the vehicle is on one of the digitised roads, navigation will begin with audio
and visual driving recommendations as soon as the route has been calculated.
Note: A compass-card symbol will appear on the display during
navigation in the following situations:
The vehicle is currently on a road that has not been digitised.
The TravelPilot E1/E2 cannot calculate a route to the destination
that you selected.
You have left the area covered by the navigation CD or you have left
the corridor that is stored in memory.
If any of these cases arise, follow the compass-card symbol. As
soon as you drive onto a digitised road again, audio and visual driv-
ing recommendations will resume.
RADIO CD / MP3 CD CHANGER SETUP
N1 DES=N
BERLIN [D]
, BERLIN,
TMC
UNTER DEN
LINDEN
A==EN=ION
OBSERVE
ROAD TRAFF
TMC
REGULATNS
FM1 NDR 2
ROUTE IS
BEING
TMC
CALCULATED
FM1 NDR 2
TMC
APPENDIX
40
NAV
NAV
NAV
NAV