Advanced; Remote Config; Dynamic Routing - Billion BIPAC 6500W User Manual

3.4.3.8 Advanced

There are six items under the Advanced section: Remote Config, Dynamic Routing, Static
Routing, Dynamic DNS, Check Email and UPnP .

3.4.3.8.1 Remote Config

Check "Enable" if you want to configure your router from any PC in the Internet world with a
web browser, such as Internet Explorer.
To configure this router remotely, use the URL "http://WAN IP address:52520" where WAN IP
address is the IP address of the router's WAN port. You can find the value in the System Status.
"52520" is the default port number; please use your own port if you change the default value.
If for any reason you want to limit the IP addresses for remote login, please enter the Start IP
and the End IP address. But be noted that the range is not allowed to exceed 254.
If the NAT function is disabled, the URL should be "http://LAN IP address" where LAN
IP address is the IP address of the router's LAN port. You can find the value in the
System Status.

3.4.3.8.2 Dynamic Routing

The dynamic routing function of the router can be used to allow the router to automatically
adjust to physical changes in the network's layout. The router uses the dynamic RIP protocol. It
regularly broadcasts routing information to other routers on the network. Choose the protocol ─
Chapter 3 Configuration
37