Main Navigation Pane; Quick Start - Billion BIPAC 6500W User Manual

3.4.1 Main Navigation Pane

Save Config : After configuring this network router, you have to save all of the configuration
parameters to FLASH.
Restart : In case the router stops responding correctly or in some other way stops functioning,
you can perform the reboot. Your setting won't be changed. Performing the reboot,
click on the Restart button. Each time you reboot your Router, the following figure will
appear. Please wait seconds for auto-reconnection.
Logout : Logout the device when you finish configuring the router.

3.4.2 Quick Start

If you use this device to access the Internet through the ISP, this web page is enough for you to
configure this router and access the Internet without a problem. Please check Chapter 3.3
(Information from the ISP), then enter the proper values into this web page, click the Apply
button and then click the Save Config button to save all of the configuration parameters to
FLASH. After the router reboot, you may check the Status web page to check whether the
router is connected to the ISP or not. In most cases, you can access the Internet immediately.
If not, please refer to the sections below for more information.
Chapter 3 Configuration
17