Factory Default Settings - Billion BiPAC 6200WZL R2 User Manual

Factory Default Settings

Before configuring the BiPAC 6200WZL R2 router, you need to know the following default settings.
Web Interface: (Username and Password)
Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
Attention
Device LAN IP settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
Obtain an IP Address Automatically
DHCP server
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are preset at the factory. The default values are shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds then release it to restore the
factory default settings.
Caution: After pressing the RESET button for more than 6 seconds then
release it, to be sure you power cycle the device again.
192.168.1.254
255.255.255.0
Enabled in ports 1, 2 and 3
100 IP addresses continuing
from 192.168.1.100 through
192.168.1.199
WAN Port
The DHCP function is
enabled to automatically get
the WAN port configuration
from the ISP.
22