Advertisement
How to....
The display memory can contain maximum 20 different user
presets. When the memory is full, the last user preset is
overwritten when a new video signal is adjusted.
When Restore Factory Settings from the Advanced menu is
selected, all the user settings, including the user presets, are
cleared.
To adjust the display to a new video signal:
a) Digital video signals:
Normally a digital video signal (on SDI or DVI-digital input) needs no
additional adjustment. If desired, you can change the color temperature
or display function in the Advanced menu. You can also perform an
Autosetup in the Adjustments menu, but only geometry will be
adjusted.
b) Analog video signals:
An analog video signal may require some adjustments the first time it is
connected.
Note: If an analog video input is selected, you can perform
Autosetup in the Adjustments menu, automatically adjusting
phase, geometry and gain offset.
If Autosetup is not available or does not give satisfactory results,
proceed as follows:
Display a dot on-dot off test pattern.
1.
Tip: You can find a suitable test pattern on the product CD-ROM.
In the Advanced menu, adjust Phase.
2.
In the Advanced menu, adjust Frequency.
3.
In the Adjustments menu, adjust Brightness, Contrast, Color, Hue
4.
and Sharpness, if necessary.
Also in the Adjustments menu, adjust Aspect Ratio and Scaling, if
5.
desired.
32
Advertisement
