Advertisement
Camera selection
This submenu lets you select from a list of camera types. The selection
provides customized settings for certain timings, as requested by the
selected camera.
Enable inputs
When you open this submenu, the list of all video inputs the display
contains, is shown. You can decide to disable some of these inputs by
using the
key.
A disabled input is not shown in the Input selection menu, nor is it
taken into account for the quick input selection, source scan system or
GPIO input switching.
When a video input is enabled, there is a check mark after its name in
the Enable inputs submenu.
Source priority
To assign priority to a video input, select the desired input from the list.
The list contains all available inputs that do not conflict with the
currently selected input source.
To disable source priority, select None.
Note: When a priority input is selected, Picture-in-Picture (PiP) is
no longer possible. The PiP menu will not be available in the OSD.
The video input to which priority is assigned, has priority over all
the other connected video sources. If that video signal is present at
its input connector, the display will automatically select that input.
If the priority signal is not present, the display will start an
autoscan and select the next input where a signal is present.
While the priority signal is present, you can still temporarily select
another input by means of the Input selection menu. However
when you exit the menu, the display automatically selects the
priority input again.
Setup
27
Advertisement
