Commands; Table 7.1: Esp-Install Program Commands - Avocent ESP Serial Hub Installer/User Manual

64 ESP Serial Hub Installer/User Guide

Commands

Table 7.1 describes the commands that may be used in the ESP-Install program. Many of the
commands contain detailed driver specifications; contact Technical Support for more information.
Syntax conventions
Keywords and values are not case sensitive.
A command must start on a line by itself. A carriage return marks the end of a command.
A comment must be on a line by itself, and must be preceded with a double slash (//).
Keyword/value pairs may have intervening spaces for readability. For example, all of the following
forms are valid:
type=esp-8
type = esp-8

Table 7.1: ESP-Install Program Commands

Command
AUTO DEVICE ON|OFF
DEBUG=[0|1]
END
ESP
F<port>=NOFLUSH ON|OFF
F<port>=NOPURGE ON|OFF
F<port>=SENDCOMMSTATUS
ON|OFF
F<port>=SENDMODEMSTATUS
ON|OFF
F<port>=TXDRAIN ON|OFF
GATEWAY=<gateway>
I<port>=RS-232|RS-485|
RS-485RTS|RS-422
f1=sendmodemstatus off
f1 = sendmodemstatus off
Description
Enables (ON) or disables (OFF) automatic responses for an unsigned
driver. The default value is ON.
Enables (1) or disables (0) inclusion of addition debug information in the
ESPinstall.log file.The default is enabled.
Designates the end of the installation/update commands for an ESP hub.
Designates the beginning of the installation/update commands for an
ESP hub.
Enables (ON) or disables (OFF) the NOFLUSH feature for the specified
physical port.
Enables (ON) or disables (OFF) the NOPURGE feature for the specified
physical port.
Enables (ON) or disables (OFF) the SENDCOMMSTATUS feature for the
specified physical port.
Enables (ON) or disables (OFF) the SENDMODEMSTATUS feature for the
specified physical port.
Enables (ON) or disables (OFF) the TXDRAIN feature for the specified
physical port.
Gateway address, in dot notation. This command is required when
installing an ESP hub that does not yet have an IP address and is not
located on the local subnet.
Interface type of the physical port. This command is valid only on multi-
interface hubs that support the specified interface type.