Port Tcp Client Command; Port Modem Emulation Command; Dialout Translation Command; Port Configuration Utility Command - Avocent ESP Serial Hub Installer/User Manual

58 ESP Serial Hub Installer/User Guide

Port TCP Client command

The Port TCP Client command enables or disables the raw TCP client connection method on one or
all serial ports. See Table 3.4 on page 19 for parameter descriptions and rules for use.
PORT <port>|ALL TCPCLIENT ENABLE|DISABLE
DESTIP=<dest_ip> [DESTPORT=<dest_port>] [LOCALPORT=<lport>]
[CONNECTMODE=AUTO|DATA|DCD] [TIMEOUT=<sec>] [BUFFERING=<hsec>]
[IDLEBUFFERING ENABLE|DISABLE]

Port Modem Emulation command

The Port Modem Emulation command enables or disables the modem emulation connection
method on one or all serial ports. See Table 3.5 on page 21 for parameter descriptions and rules
for use.
PORT <port>|ALL MODEM ENABLE|DISABLE
[INCOMING ENABLE|DISABLE] [AUTOANSWER ENABLE|DISABLE]
[LOCALPORT=<port>] [OUTGOING ENABLE|DISABLE] [DESTIP=<ip_add>]
[DESTPORT=<dest_port>] [ECHO ENABLE|DISABLE] [VERBOSE=0|1|2|3]
[RESPONSECODES ENABLE|DISABLE] [MONITORDCD ENABLE|DISABLE]
[BUFFERING=<hsec>] [TIMEOUT=<sec>]

Dialout Translation command

The Dialout Translation command is used to translate telephone numbers to an IP address and IP
port. This command is valid only when the modem emulation connection method is enabled and
outgoing calls are enabled. You may configure up to eight sets for each ESP hub serial port. See
Dialout translation on page 27 for more information.
DIALOUT_TRANSLATION PORT=<port>|ALL SET=<set_number>
NUMBER=<translate_string> IPADDR=<ip_add> IPPORT=<dest_port>

Port Configuration Utility command

The Port Configuration Utility command enables or disables the configuration utility connection
method on one or all serial ports. See Table 3.9 on page 28 for parameter descriptions and rules
for use.
PORT <port>|ALL CONFIGUTIL ENABLE|DISABLE [TIMEOUT=<sec>]

Port Attributes Command

The Port Attributes command specifies attributes for one or all serial ports.
PORT <port>|ALL [BAUD=<baud>] [SIZE=<size>]
[PARITY=NONE|EVEN|ODD|MARK|SPACE] [STOP=1|2]
[FLOW=NONE|XON/XOFF|RTS/CTS]
See Table 3.10 on page 29 for serial port parameter descriptions and rules for use.