Figure 3.12: Oscar Interface Commands Dialog Box; To Remove A Target Device From The Scan List; To Start The Scan Mode - Avocent DSR Installer/User Manual

4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press
Alt+Down Arrow
b. Press
Alt+Up Arrow
c. Press
Alt+Home
d. Press
Alt+End
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press
remaining target devices to be included in the scan pattern.
7. Click OK to save your settings.

To remove a target device from the Scan list:

1. In the Scan dialog box, click the target device to be removed.
2. Press .
Delete
-or-
Press
Shift+Delete
3. Click OK to save your settings.

To start the Scan mode:

1. If the OSCAR interface is not open, press
2. Click Commands to open the Commands dialog box as shown in Figure 3.12.

Figure 3.12: OSCAR Interface Commands Dialog Box

to move the cursor down through the list of target devices.
to move the cursor up through the list of target devices.
to move the cursor to the first target device in the list.
to move the cursor to the last target device in the list.
Down Arrow
to remove the selected target device and all entries below it.
Chapter 3: Local Port Operation
and repeat steps 2-5 for each of the
to open the Main dialog box.
Print Screen
37