Table of Contents
Advertisement
Appendix A: Restart Scenarios
Scenarios for the Restart Process
The sequence of the restart process depends on the status of the boot and application files.
This appendix explains the different scenarios possible.
Note:
The file names used in this appendix are examples only. Your particular file
Note:
names are likely to be different.
The procedures described in this appendix assume restarts occur during normal
telephone operation rather than during telephone startup.
Restart the Telephone
Use the following procedure to restart the telephone.
1. Invoke RESTART by pressing the Mute button.
2. Enter the local (dialpad) procedure password (0 to 7 numeric digits), then press the #
button.
Note:
A 6-second timeout is in effect between button presses. If you do not press a
Note:
valid button within 6 seconds of pressing the previous button, the collected digits
are discarded. In this case, no administrative option is invoked.
The entry is compared to the PROCPSWD value. If they match, the telephone displays the
Craft Local Procedure screen and prompts "Select procedure and press Start."
3. Use the navigation arrows to scroll to and highlight RESTART PHONE, then press Select
or OK. Or on a 9630 SIP IP Telephone, scroll to RESTART PHONE and press the
corresponding line button.
4. When you select RESTART PHONE from the Admin Procedure Screen, the telephone
displays a confirmation screen asking if you are sure you want to perform a restart.
Issue 2 December 2007
59
Advertisement
Table of Contents
