FLIR SR-Series Installation And Operation Manual page 37

Factory Defaults will set the TVIS-7° to factory default settings.
Change Pelco Device Address allows for users to define the Pelco Device Address. The
device will only accept commands under its new Pelco address or the global address of 99. The
TVIS GUI will only communicate using then assigned Pelco address. To query or view the
current Pelco Device Address select Tools->Options.
Camera Core Control allows the user to send a "NoOp" or No Operation command to the
Photon Core as well as "Reset" the Photon Camera. Note this Reset command does not apply
to the entire system, just the IR core.
User Defined Command Interface allows the user to send raw Photon and Pelco Commands.
For a list of Photon Commands refer to the Photon Interface Control Document (ISC Doc 102-
1238-41) and for a list of Pelco Commands refer to the ThermoVision Integration Series 7
Degree Software Interface Control Document (ISC Doc. 427-007-05-21).
System Initialization Files
TVIS-7º Saving System Files
Refresh: The screen will refresh. The device will be queried and all values will be updated.
File Save/Load: The system settings can be saved to an ".ini " file and then loaded later. Once
the settings have been loaded Save Settings to Current Power Defaults button to store the data
n the camera.
Exit: This will exit the application.
427-0014-00-10 Revision 150 Copyright © 2007 FLIR Systems, Inc. 37