Table of Contents
Advertisement
3.0 INSTALLATION
General installation information for all SR-series cameras is given below. While the general
installation procedure is the same for all cameras, there are some differences in the interfaces
and connections between various models. The instructions that are specific to certain models
are provided following the general procedures in the following sections:
4.0
SR-100 Installation
5.0
SR-100P Installation
6.0
VSR-6, SR-19, SR35, SR-50 Installation
If you have a question regarding installation or operation of your SR-Series camera, contact
FLIR Systems, Inc Customer Support, using the contact information at the front of this manual.
Check out our training web site (http://www.flir.com/training/) to get information on courses
offered and to learn how you can become a FLIR-authorized Installer.
Caution! Be sure to leave the lens cap on during the installation process so the lens does not
get damaged or dirty. Do not forget to remove the lens cap once the installation is complete,
especially if the camera is being installed in a remote or difficult-to-reach location (such as on
top of a pole).
Do not expose the camera to direct sun for long periods without the sun shroud installed.
3.1 Accessing the Electrical Connections
Video cable
gland
Power cable
gland
Hex screws
Figure 7: Rear view of SR-Series camera
427-0014-00-10 Revision 150
"T" handle
Copyright © 2007 FLIR Systems, Inc.
11
Advertisement
Table of Contents
