Table of Contents
Advertisement
2. Manual. In Manual FFC mode, the camera does not perform FFC automatically based
on specified values of temperature change or an expired time .
EZoom: Electronically multiplies the pixel array by 2, effectively doubling the image size
displayed on the monitor. 1X is turned off and 2X is turned on.
Region Of Interest (ROI) is used to define the region of the display used to generate the AGC
parameters. Full Screen ROI indicates pixel values from the entire array are used in the AGC
algorithm. The Horizon Optimized setting applies all pixel values horizontally across the screen
but uses only the middle third in the vertical direction. The Sky Optimized applies all pixel values
horizontally across the screen but only the top half in the vertical direction. The Ground
Optimized applies all pixel values horizontally across the screen but only the lower half in the
vertical direction. The other modes apply a percentage of pixel values based on the entire array
size. The ROI is centered on pixel position 0, 0 (which is the geometric center of the array).
Focus Position is adjusted by using the slider bar or the arrow keys for fine adjustment. The
"Home" button can be set by adjusting the desired focus position and then saved through the
"Save Current Settings to Power Defaults" button on the Setup Control Tab.
Focus Speed is adjusted by using the slider bar or the arrow keys for fine adjustment. The
relative set values are between 50 and 160.
Detail Enhancement or DDE: Each time this command is sent it increments the Dynamic
Display Enhancement value to the next higher setting. Default setting is 32. Valid values are 16,
24, 32, 64, 96 and 128.
LUT: The LUT or Look Up Table is a series of tables that map individual pixel values to various
color schemes or palettes. Available color palettes are White Hot, Black Hot, Sepia, Color 1,
Fire Ice, and Rain.
427-0014-00-10 Revision 150
Copyright © 2007 FLIR Systems, Inc.
34
Advertisement
Table of Contents
