Figure 16: Tongue And Groove Alignment - FLIR SR-Series Installation And Operation Manual

Enclosure Groove
Enclosure Groove

Figure 16: Tongue and Groove Alignment

5. Secure the front cover to the enclosure using the 6-32 hex head screws.
6. If the ground cable inside the enclosure was disconnected, reconnect it to the ground lug
on the rear plate of the enclosure. Connect the Earth Ground lead to the Earth Ground
Lug on the inside of the rear of the enclosure (refer to Figure 8: Earth Ground
Connection).
7. Insert the enclosure sled and rear plate into the enclosure body. Press the two
components together and ensure the O-ring is seated properly. Secure the rear plate to
the enclosure with the captive 5/64" 6-32 hex head screws.
8. Eliminate almost all of cable slack inside the enclosure. Now tighten the cable glands on
the rear of the enclosure to create an appropriate seal.
427-0014-00-10 Revision 150
Bracket Tongue
Bracket Tongue
Copyright © 2007 FLIR Systems, Inc. 22