Table of Contents
Advertisement
6.0 VSR-6, SR-19, SR35, SR-50 INSTALLATION
Prior to installing the SR-Series camera, be sure to review the general installation procedures
given above.
The VSR-6, SR-19, SR-35, and SR-50 camera systems each have a fixed-focus lens (focused
at infinity at the factory) and the lens focus is not field adjustable.
Be sure to insert the cables through the cable glands on the rear of the enclosure before
terminating and connecting to the camera (the terminated video cable will not fit through the
cable gland).
Be sure to properly ground the camera according to the information provided in section 3.2
Ground
Connection.
Caution! Proper ESD protocol should be followed while working inside the unit.
The power leads are attached directly to the connector on the interface board, as shown in
Figure 15: SR-Series Connections (VSR-6, SR-19, SR-35, and SR-50).
Remove the camera from the enclosure:
1. Loosen the two captive hex screws from the rear of the camera enclosure using the
included 5/64" hex wrench as shown in Figure 7.
2. Pull the back of the environmental enclosure off using the "T" handle.
3. Remove the two screws on the front of the enclosure as indicated in the figure below.
Do not loosen
this screw
Figure 14: Front view of SR-Series camera
4. Push the camera assembly out of the front of the enclosure from the back using the
lower left and right parts of the chassis as push points. The ground cable inside the
enclosure may have to be temporarily disconnected from the rear plate before removing
the camera.
Instructions for connecting the power, video and communication leads to the camera are given
below.
427-0014-00-10 Revision 150
Remove these hex
screws to loosen
front of enclosure
Copyright © 2007 FLIR Systems, Inc.
20
Advertisement
Table of Contents
