Installation Of Eyecup; Installation Of Demist Shield - ATN ODIN Operator's Manual

Install CR123A Lithium batteries as follows.
1. Remove the battery cap by turning it counterclockwise.
2. Check to ensure the o-ring is present. If not, replace it.
3. Observe polarity, as indicated on the outside of the battery
compartment and insert one 3.0 Volt CR123A Lithium bat-
tery into the battery compartment, minus (-) end first (Fi-
gure 2.1.).
4. Replace battery cap by pushing and turning it clockwise.
Tighten it firmly to ensure a watertight seal.
BATTERY
BATTERY CAP
FIGURE 2.1. BATTERY AND EYECUP INSTALLATION

2.1.2. INSTALLATION OF EYECUP

Perform the following procedure to install eyecup or eyeguard onto
the monocular. Refer to Figure 2.1.
(1) Carefully press the eyecup or eyeguard over the end of the eye-
piece lens.
(2) Rotate the eyecup or eyeguard into proper viewing position. Ad-
just for best fit. The eyecup must seal around your eye and prevent
the green glow from escaping.

2.1.3. INSTALLATION OF DEMIST SHIELD

Perform the following procedures to install the demist shield on the
eyepiece lens. Refer to Figure 2.1.
EYECUP
DEMIST SHIELD
2-3