Installation Of Batteries; Microsd, Usb And Hdmi Ports - ATN BINOX HD Operator's Manual

1. 0 2 . I N S TA L L AT I O N O F B AT T E R I E S
The BinoX HD will operate on three CR123 type batteries .
NOTE
We highly recommend using lithium CR123 batteries. They will provide much longer
battery life.
Install batteries as follows:
1 . Remove the Battery Cover following the arrow direction
2 . Insert batteries as shown .
3 . Close the Battery Cover .
NOTE
Make sure that the device is turned off before changing sources of energy (batteries or
USB in power supply mode).
1. 0 3 . M I C R O S D, U S B A N D H D M I P O R T S
The device is equipped with microSD, Micro USB and Micro HDMI ports . You can find them under
the rubber cover near the battery block (we marked the cover with appropriate icons) . To open the
cover you should gently lift the rubber cover and move it out of the way .
NOTE
Make sure that the device is turned off before
inserting the microSD card into the slot.
1 . A new card should be formatted before usage .
2 . Insert microSD card as shown .
3 . To lock the card in the slot push it in with a thin object
(a small coin, paper clip, toothpick, etc . ) .
4 . Return the cover to its original position .
NOTE
There is only one correct direction to insert the
microSD Card.
Do not force the card into the slot as it may damage
both the device and the card itself.
Micro USB Micro HDMI
microSD
1-3