Operator's Maintenance Procedures; Cleaning The Scope; Headmount Maintenance - ATN ODIN Operator's Manual

Thermal multi-purpose system

Table of Contents

4.3. OPERATOR'S MAINTENANCE

PROCEDURES

CAUTION

• The monocular is a precision electro-optical instrument and

must be handled carefully.

• Do not scratch the external lens surfaces or touch them with

your fingers.

• Wiping demist shield with lens paper while wet or with wet

lens paper can damage the coating.

Clean monocular with water if necessary and dry thoroughly. Clean

lenses with lens paper (and water if necessary, except for the dem-

ist shield).

a. Browpad Replacement

Replace the browpad when cracked, torn, or contaminated. Per-

form the following procedures to remove and replace the browpad.

(1) Firmly grasp the headmount and remove the old browpad.

(2) Gently press on the new browpad. Lightly smooth out any wrin-

kles in the new browpad.

b. Neck Pad Reinstallation

During operation of the Scope, it is possible for the neck pad to

become separated from its position on the headband. Perform the

following procedure to reinstall the neck pad.

(1) Lift the upper headband strap retention tab (see Figure 4.1.) al-

lowing the neck pad strap to be inserted underneath.

(2) Slip the neck pad strap all the way under the upper strap reten-

tion tab and then pull the lower part of the neck pad strap under the

lower strap retention tab.

(3) Repeat steps 1 and 2 for the other side of the headband and

neckband if necessary.

4-5

Table of Contents