Installation Of Headmount With Protective Mask - ATN ODIN Operator's Manual

(10) Engage the nape strap at the nape strap latch. Tension the
nape strap for a stable fit, then install and tension the helmet chin-
strap. The brow of the helmet should be parallel to the ground and
the helmet stable on the head.
(11) Insert the top edge of the mount under the keeper on the helmet
mount bracket and rotate downward until the latch engages (see
Figure 2.6.). To release the mount from the helmet bracket, press
the release and pull forward and down.
KEEPER
HELMET
MOUNT
BRACKET
FIGURE 2.6. REASSEMBLY OF HELMET MOUNT
2.1.7. INSTALLATION OF HEADMOUNT
WITH PROTECTIVE MASK
Perform the following procedures for donning headmount with pro-
tective mask.
(1) Place protective mask on your head per the instructions pro-
vided with the protective mask.
WARNING
When installing the headmount over the protective mask, be
careful not to break the protective mask seal around your face.
(2) Install the headmount per the instructions in paragraph 2.1.4.
NOTE
It may be necessary to remove the browpad (Figure 2.2.) when
wearing the headmount over a protective mask.
2-8
TOP EDGE
OF MOUNT
RELEASE
MOUNT
LATCH