Table of Contents
Advertisement
Note: x is the registered handset number and y is the registered DECT base.
Un-register / Reset your DCT-100
•
Press the INT button before power on the handset.
•
Power on the handset, and DO NOT release the INT button till the LCD displays "F->clear
Subs"
•
Press the down button to clear the handset settings.
•
Power off, power on handset again, the handset will display "Not Sub", and it is now not registering
to any DECT base.
Call transfer between DCT-100
During handset 1 (HS1) conversation, press the INT button and enter the desired
•
handset number. (in this sample, we press the 2 to transfer the call to HS2)
The desired handset 2 (HS2) will ring, press the
•
At this moment, press the
•
transferred to the handset 2 (HS2).
If the handset 2 not answer the call, and you'd like to cancel the transfer. On handset 1
•
(HS1), press the INT button, the call will be re-connected handset 1 (HS1) again.
Conference call between DCT-100
During conversation, press the INT button, and there will be "Intercom" message
•
displayed on the LCD screen.
Press the handset number you'd like to add in the voice conferencing. At this moment,
•
you may hear the ringing tone from the destination handset.
Start voice conversation with the destination handset, and you may now press the # key
•
for 3 seconds, and the destination handset will be joined in the voice conferencing.
VIP-320 DECT base settings
The DECT base settings in VIP-320 have been optimized for most voice communication
applications. It is not necessary to change the parameters in most occasions.
button on handset 1 (HS1), the voice call is now
button to answer the call.
43
Advertisement
Table of Contents
