Reset Button - Planet PL-802 User Manual

600m av2 powerline ethernet bridge

Hide thumbs Also See for PL-802:

Table of Contents

Step 9

Press and hold the Security button on Bridge A for 1~3 seconds. The Power lights on

Bridge A and starts to flash.

Step 10

Within 120 seconds after the Power lights on Bridge A and starts to flash, press and

hold the Security button on Bridge C for 1~3 seconds and then release.

Step 11

Bridge A, Bridge B and Bridge C are now networked to each other.

3.6 Reset Button

This section describes how to use the Reset button, which can be used to clear ALL data and restore

ALL settings to the factory default values.

The procedure is as follows:

Step 12

Hold the Reset button down while powering on for a few seconds.

Step 13

Release the Reset button.

Step 14

All the LEDs will be off, and then start again.

Step 15

The PL-802 is now using the factory default values.

User's Manual of PL-802

Table of Contents