Call Setup - Planet VIP-320 User Manual

Please remember to press the modify button to take it effect. For store back to flash memory, please
press "Save Modification" (Plaase refer to the "Syetem Maintenance

Call Setup

This page defines the optional special VoIP parameters when making/received a VoIP call. For define
some special parameters for different VoIP equipment or authorize purpose, please add a profile at
"VoIP Config Call Routing
Routing Table" (Please refer to the "VoIP Config
Routing table" (Please refer to the "VoIP Config
Name
VAD
CODEC
H.245 tunneling
DTMF Relay
T.38 FAX Relay
Call Setup", and use the same name as the profile on the "Call in
Parameter Description
Specify a profile name. Please use UNDERLINE to replace the SPACE
due to HTTP protocol limitation.
ON: turn on the VAD (Voice Activity Detection) function.
OFF: turn off the VAD function, please select ON for save the
bandwidth.
Select different voice CODEC for VoIP communication. The bit rate of
G.723.1 is 5.3k/6.3k, G.729 is 8k, uLaw and aLaw is 64k per second.
The G.723.1 is default CODEC.
ON: to enable H.245 tunneling.
OFF: to disable H.245 tunneling.
When select UIn bandU to transfer the DTMF during VoIP, the user
pressed DTMF tone will be treat as general voice and been compressed
then transmit to remote side to decompress play back, it maybe cause
some problem on duplicate or missing DTMF receive.
When select "Out band" to transfer the DTMF during VoIP, the user
pressed DTMF tone will be decode by local VoIP router then transmit as
signal, after received on received remote VoIP router, it will be
regenerate by remote VoIP router. The default value is Out band.
ON: FAX will be transmitted by using T.38 FAX over IP protocol.
Call Routing VoIP Call In") or "Call out
Call Routing VoIP Call Out").
Save Modification").
27