Table of Contents
Advertisement
become annulment!
2.
Press
button to show [EW361001] (Firmware)
This setting is to show the base firmware version.
Press * button and the display will show DEFAULT N
Press
and
button to switch to DEFAULT Y
Time for reload factory default is 2 seconds then will display OK
This setting use to reset default factory default.
Press * button to switch to PROTECT Y
Press
and
button to switch to DEFAULT Y
This is used for system protection.
Please DO NOT change factory default value, the DCT-100 may
become annulment!
3.
Press
button to select [F TM 600?] and setting Flash time
During the call, press
Press
and
button to change to F TM 130 (ms)
Press
and
button to change to F TM 260 (ms)
Press
and
button to change to F TM 390 (ms)
Press
and
button to change to F TM 600 (ms)
This setting is setting for different flash time.
4.
Press
button to select [Line out 123]
Press
to switch Line out 123 or Line in 123
Press
/ /
and
Line out 123
default
Line in 123
default
This setting is setting Line-in/Line-out.
Please DO NOT change factory default value, the DCT-100 may
become annulment!
5.
Press
button to delete subscriber (handset) mode
Press the handset number and
This setting is using for de-register subscriber (handset).
default
button can switch to another call.
button to enable or disable Line 123
button to de-register this handset.
default
reload factory
default
EW3TIJ05
DEFAULT N
PROTECT Y
F TM 600 ?
Line out 123
H DeSub ?
45
Advertisement
Table of Contents
