Table of Contents
Advertisement
Tone Config
This page defines the tones generated to the phone connected to the phone port. All lines use same
tone parameters. After modify the tone parameters, you must save modify then Reboot to let the
modified parameters work.
Detect Voice Busy Cycle
Tone define Table
Tone
Type
Low freq
High freq
T_ON_1,T_OFF_1, T_ON_2,
T_OFF_2
number. That mean it will direct call out by VoIP when you off hook the
phone of this line.
Parameter Description
Use the parameters to automatic detect cadence busy tone. When
detected a voice cadence repeat over this parameters setting in
sequence, the VoIP router will treat it like busy tone and disconnect
automatically. Please do not set this parameter less than 5 to avoid
unexpected erroneous disconnect.
You can set up to 15 tones set for detection and generation. For the
generation, the first entry will be used. The call progress tones, ranging
from 300 Hz to 2000 Hz, are defined for both generation and detection.
Generation, however, can be defined from 1 Hz to 3980 Hz.
Maximum 15 tones can be defined.
Dial: Define the generated dial tone for phone set
Busy: Define the busy tone for generate & detect
Ring: Define the ring back tone for generate
Lower frequency for defined tone
Higher frequency for defined tone. Each tone can define two
frequencies, if only one frequency needed, please leave High
Frequency to 0.
The cadence pattern of up to four intervals for each dual-frequency.
Minimum Cadence value is 30msec.
21
Advertisement
Table of Contents
