Table of Contents
Advertisement
DCT-100 installation
The three rechargeable Ni-MH batteries (AAA size) come with your phone. Install the batteries before
using your phone.
1. Slide the battery cover in the direction of the arrow and pull it out.
2. Remove old batteries, if any, and insert new batteries as indicated, matching correct polarity (+, -).
3. Replace the battery cover, slide the cover up until it snaps shut.
Note
Note
Register your DCT-100 to VIP-320
•
Press Intercom button on VIP-320 for 5 seconds until the Paring LED lights.
•
Press
key to go into manual option.
•
Select HS register
•
Press INT key.
This phone won't work by itself. It should be registered
to the main base unit inside the VIP-320.
Before initial using, it should be charged for 24 hours.
Reversing the orientation may damage the handset.
The battery needs to be replaced if it does not recover
its full storage capacity after recharging.
When replacing batteries, always use good quality Ni-MH
re-chargeable AAA size batteries.
Never use other batteries or conventional alkaline
batteries.
11
Advertisement
Table of Contents
