Enable The Gateway; Create A Sip Service; Registering With A Registrar (Optional) - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series
Hide thumbs Also See for SmartNode Series:
Table of Contents

Advertisement

SmartWare Software Configuration Guide

Enable the Gateway

In order to become active the SIP gateway must be enabled. The following procedure enables the SIP gateway:
Mode: Gateway SIP
Step
1
node (gw- sip )[ sip ]#no shutdown
Example: Enabling an SIP Gateway Configuration
The following example shows how to enable an already defined SIP Gateway.
node(cfg)#gateway sip sip
node(gw-sip)[sip]#no shutdown

Create a SIP service

SIP gateways can be configured for use with multiple SIP services at the same time. Therefore there is a sub-
mode service <name> within the gateway SIP. It is necessary to specify in the SIP interface, which service of the
gateway shall be used for this interface using the

Registering with a registrar (optional)

If necessary, the SIP gateway can register one or more users with a SIP compliant registrar. If the gateway is
used as a gateway to the PSTN, this functionality is usually not required. However, if the gateway is responsible
for terminals, which are directly attached to it, it is often required that the gateway registers the phone numbers
or usernames associated with these terminals with a registrar.
Procedure: To register users with a SIP registrar
Mode: Gateway SIP/service
Step
1
node (svc-sip)[service]#registrar address [port]
[ use-default-server ]
Gateway configuration task list
Command
service
Command
40 • SIP gateway configuration
Enable the SIP gateway
command.
Specify the registrar server to be used for reg-
istration.
The address may be either an IP address or a
name to be resolved by DNS.
It is also possible to specify a SIP domain
name to be resolved using DNS SRV records
as the address.
If the registrar uses a different UDP port.than
the default port 5060 for receiving mes-
sages, the port number can also be specified
here.
If the use-default-server parameter is speci-
fied, the REGISTER messages will be sent via
the default server instead of directly to the
registrar.
Purpose
Purpose
505

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartware release 3.21

Table of Contents