Configuring Hdlc Crc-Type; Configuring Hdlc Encapsulation; T1/E1 Configuration Examples - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series
Hide thumbs Also See for SmartNode Series:
Table of Contents

Advertisement

SmartWare Software Configuration Guide
tion mode the encapsulation must be set to 'hdlc' as well followed by configuring at least one timeslot per the
'timeslots' command.
Mode: port e1t1 <slot> <port>
Step
[ name ] (prt-e1t1)[slot/port]# hdlc
1
Mode: channel-group <group>
Step
1
[name] (ch-grp)[group-name]#hdlc
Configuring HDLC CRC-Type
This command specifies the length of the checksum for calculating the CRC of the hdlc-frame. It can be either
a 16-bit or a 32-bit checksum.
Mode: hdlc
Step
[ name ] (hdlc)#crc-type {crc16 | crc32}
1
Configuring HDLC Encapsulation
The hdlc encapsulation command specifies what kinds of upper layer data are contained in the hdlc frames.
Two encapsulation types are available, framerelay and ppp. Once the hdlc configuration mode has been
entered, the procedure for setting up framerelay or ppp is exactly the same as for an X.21/V.35 serial port. For
that reason, see chapter 14,
ration and chapter 25,
"PPP configuration"
Mode: hdlc
Step
[ name ] (hdlc)#encapsulation {framere-
1
lay | ppp}
T1/E1 Configuration Examples
Here is a group of four configuration examples.
Example 1:Frame Relay without a channel-group
Example 2:Frame Relay with a channel-group
Example 3:PPP without a channel-group
Example 4:PPP with a channel-group
T1/E1 port configuration task list
Command
Command
Command
"Serial port configuration"
on page 270 for PPP configuration.
Command
15 • T1/E1 port configuration
Purpose
Entering the hdlc configuration mode
Purpose
Entering the hdlc configuration mode
Purpose
Selects the checksum-type to be used.
Default: crc16
on page 161 for more details about frame relay configu-
Purpose
Specifies the encapsulation type of hdlc.
Default: no encapsulation
187

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartware release 3.21

Table of Contents