Sip Profile - Patton electronics SmartNode Series Software Configuration Manual

Software for smartnode series
Hide thumbs Also See for SmartNode Series:
Table of Contents

Advertisement

SmartWare Software Configuration Guide
Example: Defining the call transfer version
The following example shows how to use the implementation of the call-transfer according to draft-ietf-sip-cc-
transfer-02.
node(cfg)#gateway sip sip
node(gw-sip)[sip]#service default
node(svc-sip)[service]#call-transfer-version 2
SIP Profile
There is a new profile type, the SIP profile. It allows to specify disconnect cause mappings from SIP cause
codes to Q.931 cause codes, and vice versa.
As for all profiles, at system startup a profile called default exists, which can also be modified. As default, all SIP
gateways and interfaces use this profile default.
Only those causes have to be configured that differ from the default mapping. If a new profile is created, all
mappings are set to their default and only overwritten if configured. The default mapping in both directions is
according to RFC3398 - ISUP to SIP Mapping.
Mode: Configure
Step
1
[ name ] (cfg)# [no] profile sip name
2
[ name ] (pf-sip)[ name ]# map cause from-
sip sip-cause to q931-cause
3
[ name ] (pf-sip)[ name ]# map cause to-sip
q931-cause to sip-cause
Mode: gateway sip/service
Step
1
[ name ] (svc-sip)[service]# use profile sip
name
Mode: interface sip
Step
[ name ] (if-sip)[ name ]# use profile sip name Specifies the usage of a specific SIP profile
1
Gateway configuration task list
Command
Command
Command
40 • SIP gateway configuration
Purpose
Create a new SIP profile/enter SIP profile
configuration mode.
Maps a specific SIP disconnect cause to a
Q.931 cause. Use tab completion for a com-
plete list of possible values for both
cause types.
Maps a specific Q.931 disconnect cause to
a SIP cause code. Use tab completion for a
complete list of possible values for both
cause types.
Purpose
Specifies the usage of a specific SIP profile
on this gateway. If no profile is configured,
profile "default" is used.
Purpose
on this interface. If no profile is configured,
profile "default" is used.
512

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartware release 3.21

Table of Contents